-
- Arduino Shield & Module
1 Channel 5V Relay Board Module
- ৳90.00
- It has a relay status indicator led Power LED(Green), relay status indicator LED(Red) Relay control interface by single-chip IO. Low-level suction close, high-level release. Easy to use, simple 3 line structure.
- Add to cart
-
- Arduino Shield & Module
125KHz RFID Card
- ৳40.00
- Specifications: Contactless transmission of data and supply energy (no battery needed) Operating distance: Up to 1 to 5 cm (Depending on Antenna Geometry) Operating frequency: 125KHz Data transfer: 106 kbit/s Data integrity: 16 Bit CRC, parity, bit coding bit counting Anti-collision Printable
- Add to cart
-
- Arduino Shield & Module
16×2 LCD Keypad Shield
- ৳359.00
- 1602 LCD Keypad Shield for Arduino
- Add to cart
-
- Arduino Shield & Module
2 Channel 5V Relay Board Module
- ৳130.00
- Low Level Trigger Relay Module. RoboticsBD Two separate LEDs for On/Off indication of the Relay. Triggering input voltage 3.3V – 5V Two separate LEDs for On/Off indication of the Relay Triggering input voltage 3.3V – 5V 4) Back EMF protection Back EMF protection 2 LEDs to indicate when relays are ON. Works with logic level signals from 3.3V or 5V…
- Add to cart
-
- Arduino Shield & Module
4 Channel 5V Relay Board Module
- ৳280.00
- No. of Channel: 4 Trigger Voltage: 5VDC Triode drive, increasing relay coil High impedance controller pin Pull-down circuit for the avoidance of malfunction Power supply indicator and Control indicator lamp Power supply and relay instructions, lit, the disconnect is off; The input signal, signal, common Terminal and start conducting;
- Add to cart
-
- Arduino Shield & Module
4×4 Keypad – 16 Key – Matrix Membrane Type
- ৳70.00
- Ultra-thin design & adhesive backing provides easy integration to any project. Excellent price-performance ratio. Easy communication with any microcontroller 5 pins 2.54mm pitch connector, 4x 4type 16 keys. Sticker can peel off for adhesive mounting.
- Add to cart
-
- Arduino Shield & Module, Cables & Connector, Development Board
50 cm Cable For Arduino UNO/MEGA (USB A to B)
- ৳100.00
- USB Type: Type-A to Type-B Weight: 26 gm. Length: 50 cm Long cable for easy work Fully compatible with the PC. Molded strain relief and PVC over-molding to ensure a lifetime of error-free data transmissions.
- Add to cart
-
- Arduino Shield & Module
5V 1 Channel Solid State Relay (SSR)
- ৳350.00
- Power supply:5VDC/160mA Switching Voltage (VAC):240@2A Isolation: Phototriac
- Add to cart
-
- Arduino Shield & Module
5V 2 Channel Solid State Relay (SSR)
- ৳490.00
- Part Number: G3MB-202P Power supply:5VDC/160mA Trigger Voltage (VDC):5 Switching Voltage (VAC):240@2A Isolation: Phototriac
- Add to cart
-
- Arduino Shield & Module
5V 4 Channel Solid State Relay (SSR)
- ৳850.00
- Part Number: G3MB-202P Power supply:5VDC/160mA Trigger Voltage (VDC):5 Switching Voltage (VAC):240@2A Isolation: Phototriac
- Add to cart
-
- Arduino Shield & Module, BMS & Charger, Transformer
5v DC Step Down Transformer Power Supply Module
- ৳180.00
- 5v DC Step Down Transformer Power Supply Module
- Add to cart
