-
- Communication Module, Drone Item
1000TVL Mini FPV Camera Lens 2.8mm 3MP
- ৳1,299.00
- Features: -With 1/3” CCD sensor -With lens cover,well protecting the lens -With WDR function in default -Without OSD -Super lightweight,ultra-low power consumption,suitable for RC multicopter
- Add to cart
-
- Communication Module
Bluetooth Module (HC-08)
- ৳295.00
- Frequency: 2.4GHz ISM Protocol: BLE 4.0 Max transmitting power: max. 4dBm Modulation System: GFSK Serial Baud Rate: 1200 to 115200 bps Reference Distance: 80 meters Speed: 1Mbps (Max) Power supply: 2.0 - 3.6 V Sleep Mode Current: 0.4uA (MODE 2) Communication Port: UART 3.3V TTL Working temperature: -20 ~ +75 Centigrade Dimension: 26.9mm x 13mm x 2.2 mm Half-cut hole…
- Add to cart
-
- Communication Module
Bluetooth Module Breakout (HC-05)
- ৳325.00
- Bluetooth protocal: Bluetooth Specification v2.0+EDR Frequency: 2.4GHz ISM band Modulation: GFSK (Gaussian Frequency Shift Keying) Emission power: <= 4dBm, Class 2 Sensitivity: <= -84dBm at 0.1?R Speed: Asynchronous: 2.1Mbps(Max) / 160 kbps, Synchronous: 1Mbps/1Mbps Security: Authentication and Encryption Profiles: Bluetooth serial port Power supply: +3.3 VDC 50mA Working temperature: -20 ~ +75 Centigrate Dimension: 26.9mm x 13mm x 2.2 mm
- Add to cart
-
- Communication Module
Bluetooth Module Breakout (HC-06)
- ৳315.00
- Typical -80dBm sensitivity. Up to +4dBm RF transmits power. Low Power 1.8V Operation, 3.3 to 5 V I/O. PIO control. UART interface with programmable baud rate. With integrated antenna. With edge connector. Slave default Baud rate: 9600, Data bits:8, Stop bit:1, Parity: No parity Auto-connect to the last device on power as default. Permit pairing device to connect as default.…
- Add to cart
-
- Arduino Shield & Module, Communication Module, Converter Module
DC 8-24V Stereo Digital Amplifier Board DY-AP3015
- ৳395.00
- Parameters: Product name:DY-AP3015 Stereo Power Amplifier Module Model:DY-AP3015 Work Voltage:DC 8V-24V Work Mode:Class D(PWM) Channel:Dual channel Output Power: Output power 18W*2 at 12V 4ohm Output power 10W*2 at 12V 8ohm Output power 15W*2 at 16V 8ohm Output power 20W*2 at 20V 8ohm Output power 30W*2 at 24V 8ohm(Need to add an extra heat sink!) Match speaker(30W~150W): 4ohm at 8V~12V 8ohm…
- Add to cart
-
- Arduino Shield & Module, Communication Module, Converter Module
Digital Audio Power Amplifier Board Amp TPA3118 Mono Module
- ৳245.00
- Power amplifier chip: TPA3118 Working Voltage: DC 8-24V Power Output: 1*60W(one Channel, requiring two stereo) Applicable Speaker Impedance: 4-8 ohm Product size: approx. 46*35*11mm/1.81*1.37*0.43'' Net weight: approx. 13g
- Add to cart
-
- Arduino Shield & Module, Communication Module
DT-06 Wireless WiFi Module
- ৳380.00
- DT-06 Wireless WiFi Module
- Add to cart
-
- Arduino Shield & Module, Communication Module
GPRS GSM SIM900
- ৳2,300.00
- Based on SIMCom‘s SIM900 Module Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world. Control by AT commands - Standard Commands: GSM 07.07 & 07.05 | Enhanced Commands: SIMCOM AT Commands. Short Message Service - so that you can send small amounts of data over the network (ASCII or…
- Add to cart
-
- Arduino Shield & Module, Communication Module, IR Sensor, Sensors
Infrared Remote Control Module HX1838
- ৳370.00
- Sensor uses HX1838, high sensitivity.2. Operating voltage 5V.3. Output form: Digital output.4. VCC: 3.3V-5V external voltage (can be directly connected to the 5v microcontroller and 3.3v microcontroller).5. GND: external GND.6. IN: external microcontroller I/O port, I/O port has been designed 10K pull-up resistor.7. Kit theory test distance of about 5-8 meters, but the practical application depends on the ambient factors…
- Add to cart
-
- Arduino Shield & Module, Communication Module
ISD1820 Voice Recording Module
- ৳300.00
- 1. Push?button interface, playback can be edge or level activated 2.Automatic power?down mode 3.On?chip 8? speaker driver 4. Signal 3.3V Power Supply 5.Can be controlled both manually or by MCU 6.Record up to around 10 seconds of audio
- Add to cart
-
- Arduino Shield & Module, Communication Module, Converter Module
NRF24L01 Wireless Adapter Module Socket
- ৳215.00
- Specification: Input Voltage: 5V DC Output Voltage: 1.9~3.6 DC Current: 12.3 mA It’s for 8 Pin NRF24L01+ Module A simple socket board which is for NRF24L01 wireless module On-board AMS1117-3.3 chip It can be used with NRF24L01 wireless module Dimension: 26 x 19 x 12mm
- Add to cart
